Name: How to Make the Bob Box! Date: 1/23/90 Time: 7:32 pm Press [Ctrl-X] to abort or [Ctrl-S] to pause! I know all you major phone tappers are probably all sitting there going "Oooooo! Ahhhhh!" and I know what you're saying... but this is for the guys/girls who have some electrical knowledge, but not enough to put some- thing together by themselves...(like this, anyway.) Here we go. I: THE BEIGE BOX Also commonly referred to as the "Bud Box". This is extremely simple to construct, and doesn't take much time. First, get about a 12 foot phone cord. Regular. They cost about uh...$2.50 at K-Mart or something. Second, cut off one of the ends of it. (ie, cut the little plastic thingy off). Third, cut some of the plastic stuff off; like get a razor blade and cut it, but don't cut the wires inside. (Very tricky). Fourth, when you see the wires inside, there should be a red, a green, a yellow, and a black. Ignore the yellow and black. In fact, cut them off. Now strip some of the little red and green plastic off. (Yes, with your razor blade). Now get out your soldering gun! (Oh, did i forget to mention that?) Now, get some solder and some alligator clips. (Available at Radio Shack for about $1.10 for 10 of them). Now solder the green wire to one clip, and the red to another. Simple? You've finished your first phone 'tap'. Now, grab your fone, (ie, the receiver), and head outside. In your backyard, there should be a silver box with "BELL" written on it. They're not that hard to find, usually, you can just look up at the telephone poll and there are wires leading down. Anyway--pop off the little box. If it doesn't budge, go grab a screwdriver. Now unscrew the big screw at the bottom of the box. NOW pop it off. There should be screws and wires that look some- thing like this: *(red wire) *(green wire) *(screw) *(yellow) *(black) Or something along those lines. The little asteriks are screws. Usually, (at least around my neighborhood), the green alligator clip goes to the green screw, and the red to the red. It could be different, however, so switch them around if needed. I don't think the bottom screws are ever needed, unless the house has another separate fone line. And be careful! I got shocked once, and it wasn't very phun.. Alright, so that's basic, and it's very easy to get caught with, so don't try it unless your neighbors aren't going to be home for a long time, or are on vacation. A neato nifty thing to do is to stick an automatic recorder in their little box. (When i say 'their', I am referring to your victim's). They're available at Radio Shack for $19. Pretty steep unless you're a rich kid, which i'm not, but that's another story. So, you rip one off. (Haha, joke... I do NOT condone stealing things). Ok, so anyway, you buy one from Radio Shack for $19, use it until you don't need it anymore (up to 30 days, usually), and then take it back... if it's in good condition. Anyway (for the 4th time), you get a microcassette recorder (you can buy mine!) and stick your little contraption in the silver Bell box. Then the recording will start when they pick up the fone, and stop automatically when they're done. Just make sure your neighbors don't check their Bell box often. (And *REMEMBER*, the fine for evesdropping is 5 years and $10,000.. the CHOICE is YOURS... hehehehe). II: WIRELESS TRANSMITTER PLANS This is a transmitter that consists on a one colpitts oscillator that takes its power from the fone line. Since the resistance it puts on the line is less that 100 ohms, it has no effect on the telephone performance, and can't be detected by your neighbors or Ma Bell. Since it's a low-powered device that doesn't use an antenna for radiation, it is legal to the FCC... BUT--Not legal for what we're going to do with it! What it does, is use four diodes to form a bridge rectifier. It produces a varying DC voltage varying with the auto-signals on the line. That voltage is used to supply the voltage for the oscillator transistor. Which is connected to a radio circuit. From there, you can tune it to any channel you want. The rest will be explained inn text. PARTS LIST Item Description =========================================================================== C1 47-PF CERAMIC DISK CAPACITOR C2,C3 27-PF MICA CAPACITOR CR1, CR2, CR3, CR4 GERMANIUM DIODE 1N90 OR EQUIVALENT R1 100 OHM, 1/4 WATT 10% COMPOSITION RESISTOR R2 10K, 1/4 WATT 10% COMPOSITION RESISTOR R3 .7K, 1/4 WATT "" "" L1 2 UH RADIO FREQUENCY CHOKE (SEE TEXT) L2 5 TURNS NO. 20 WIRE (SEE TEXT) Q1 NPN RF TRANSISTOR 2N5179 OR EQUIVALENT ========================================================================== L1 may be constructed by winding approx. 40 turns of No. 36 enamel wire on a mega-ohm, 1/2 watt resistor. The value of L1 is not critical. L2 can be made by wrapping 5 turns of No. 20 wire around a 1/4 inch form. After the wire is wrapped, the form can be removed. Just solder it into place on the circuit board. It should hold quite nicely. Also be sure to position Q1 so that the emitter, base, and collector are in the proper hols. The schematic should be pretty easy to follw. Although it has an unusual number of grounds, it still works. -----------------L1---------------------- CR1/ \CR2 --------------- ----A-----------------/ \ --- ---\ / C2 L2 CR3\ /CR4 C1 R2 ----R1 -- GND C3 ---- ----GND ---------BASE COLLECTOR R3 \ / B----------------- ----------- \/\ <- Q1 GND \/ EMITTER (GND) Ok, now go to the box, remove the red wire that was already on Screw 1, and attach it to wire "A" of the bug. Then attach wire "B" to the screw itself. You can adjust the frequency which it comes out on the FM channel by either smashing, or widening thec coils of L2. It takes a few minutes to get to work right, but it is also very versatile. You can change the frequen- cy at will, and you can easily record off your radio. X-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-X Another file downloaded from: The NIRVANAnet(tm) Seven & the Temple of the Screaming Electron Taipan Enigma 510/935-5845 Burn This Flag Zardoz 408/363-9766 realitycheck Poindexter Fortran 510/527-1662 Lies Unlimited Mick Freen 801/278-2699 The New Dork Sublime Biffnix 415/864-DORK The Shrine Rif Raf 206/794-6674 Planet Mirth Simon Jester 510/786-6560 "Raw Data for Raw Nerves" X-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-X